Werbung
Description
®
Mitel
5505 Guest IP Phones are supported by the 3300 Integrated
Communications Platform (ICP) with MCD Release 5.0 or later software.
The Mitel 5505 Guest IP Phone and 5505 Cordless Handset provide a
SIP-based IP guest room phone. The 5505 Guest IP Phone supports up to four
5505 Cordless Handsets. You can order additional 5505 Cordless handsets
and chargers.
The 5505 Cordless Handset has an indoor signal range of up to 100 meters
(300 feet) from the 5505 Guest IP Phone.
Supporting Documentation
To access phone- and system-specific documentation:
1. In your browser, go to http://www.edocs.mitel.com, and log in if necessary
using your Mitel Online account information.
2. Move your cursor over End User Documents and select PDF Guides to
access any user guides.
3. In Other Resources, click Installation Guides for end User Devices to
access any installation guides.
Preparing the 5505 Cordless Handset and Installing the
Batteries
1. The display is protected by a plastic film. Remove the protective film.
2. Insert the batteries as designated on the back of the handset. The polarity
is indicated on the battery compartment.
3. Slide the battery cover back into the main casing until it clicks into place.
Battery Specifications
Technology: Nickel-metal-hydride (NiMH)
Size:AAA (Micro, HR03)
Voltage:1.2 V
Capacity:400–800 mAh
Mitel recommends the following types of batteries:
• GP GP55AAAHCR 550mAh
• SHP HFR-44AAAJ550 550mAh
• SUPPO HSY-AAA0.55-C 550mAh
The 5505 Cordless Handset is supplied with the recommended batteries.
Charging the 5505 Cordless Handset
1. Charge the battery. It is recommend that you charge the battery fully before
first use. It takes approximately 8 hours to fully charge the battery.
2. Then remove the handset for use.
3. Do not return the handset to the charger until the batteries are fully
discharged.
Connecting and Registering the 5505 Guest IP Phone
The 5505 Guest IP Phone comes pre-paired with one 5505 Cordless Handset.
Follow the instructions below to connect and register the first 5505 Cordless
Handset and 5505 Guest IP Phone base station.
Turn on the Handset and Prepare the Base Station
1. Turn on the 5505 Cordless Handset using the power on button.
2. Set up the 5505 Guest IP Phone at a central location on a flat, non-slip
surface. Turn the 5505 base station so that the front faces away from you.
Connect the 5505 Base Station
A
(See Figure
)
Thread the LAN cable plug through the slot on the back of the installed base
unit and plug it into the LAN port on the back of the phone.
Plug the other end of the LAN cable into one of the following:
• the phone port of an Ethernet power adapter. Then, connect the
Ethernet adapter to the LAN using a separate LAN cable, and plug the
power adapter into an AC power outlet.
or
• a LAN-powered jack.
The base unit initializes and establishes a connection with the 5505
Cordless Handset. The 5505 Cordless Handset will stop flashing "Base"
indicating the successful DECT connection.
4
Werbung
