Dolmar MS-4300.4 R Originalbetriebsanleitung Seite 12

For nylon cutting head
Be sure to mount the nylon cutting head protector (10) onto the type A metal
●
blade protector (3) assembled with the nylon cutting head protector.
Mount the nylon cutting head protector (10) by sliding it into place from the
●
flank of the metal blade protector (3).
Remove tape adhered to cutter, which cuts nylon cord, on nylon cutting head
●
protector (10).
CAUTION:
Be sure to push in nylon cutting head protector (10) until it is fully inserted.
●
Take care not to injure yourself on the cutter for cutting the nylon cord.
To remove the nylon cutting head protector (10), apply a hex wrench (11) into
●
the notch on the metal blade protector (3), push it in and meanwhile slide the
nylon cutting head protector (10).
12
(3)
(10)
(11)