OHAUS TD52 Bedienungsanleitung Seite 6

EN-4
2. Rotate the rear housing down away from the front housing as
shown.
Connect the 12-pin Cable Connector included with the kit to the
3.
Main Board Connector 2. Place the ferrite in the slot of the black
part as shown.
4. Disassemble the M25 Cable Gland by loosening the cap nut and removing
the rubber seal. Pass the Current Loop Output cable through the cap nut,
then spread the rubber seal and place it over the cable. Now pass the
cable through the body of the cable gland.
Cable
Main board connector 2
M25 Gland
Cap nut
Ferrite
4~20mA Current loop
output cable