OHAUS TD52 Bedienungsanleitung Seite 12

EN-10
7. Fasten the cap nut of M25 gland to rear housing. Put the rear housing
back on the front housing. Re-install the 6 screws (Torque is 1.8N*m±
0.5).
8. Warp the rubber seal onto Current Loop Output cable and Push it to the
hole.
9. Fasten the cap nut of M25 gland.
ANALOG CONFIGURATION
Communication
Source
Output Type
Zero Value
Analog
Full Scale Value
Cal Output Zero
Cal Output Full
Options (bold is default)
None, Displayed Weight, ABS-Displayed Weight,
Gross Weight
4-20mA, 0-10V
0 (any valid value below the upper limit)
Desired source value, scale capacity
Cap nut of M25 gland
Rubber seal
Cap nut of M25 gland