SMA SUNNY BOY 1.5 Schnelleinstieg Seite 6

3 Symbols on the Product
CAUTION
Risk of burns due to hot enclosure parts
Some parts of the enclosure can get hot during
operation. Touching hot enclosure parts can result
in burn injuries.
• During operation, do not touch any parts
other than the enclosure lid of the inverter.
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly
or dropped while being transported or mounted.
• Transport and lift the product carefully. Take
the weight of the product into account.
• Wear suitable personal protective equipment
for all work on the product.
NOTICE
Damage due to cleaning agents
The use of cleaning agents may cause damage to
the product and its components.
• Clean the product and all its components
only with a cloth moistened with clear water.
NOTICE
High costs due to inappropriate Internet
tariff
Depending on use, the data volume of the product
transferred via the Internet may vary in size. The
data volume depends, for example, on the number
of inverters in the system, the frequency of device
updates, the frequency of data transfer to
Sunny Portal or the use of FTP push. High costs for
the Internet connection can be the result.
• SMA Solar Technology AG recommends
using an Internet flat rate.
Change to the names and units of
grid parameters to comply with the
grid-connection requirements in
accordance with Regulation (EU)
2016/631 (valid from April 27,
2019)
To comply with the EU grid-connection requirements
(valid from April 27, 2019) the names and units of
grid parameters were changed. This change is valid
from firmware version ≥ 3.00.00.R if a country data
set for fulfilling the EU grid-connection requirements
(valid from 2019-04-27) is set. Names and units of
grid parameters for inverters with firmware version
≤ 2.99.99.R are not affected by this change and
remain valid. This also applies from firmware version
≥ 3.00.00.R if a country data set that is valid for
countries outside the EU is set.
6 SBxx-1VL-40-IS-xx-19
SMA Solar Technology AG
3 Symbols on the Product
Symbol Explanation
Beware of a danger zone
This symbol indicates that the product
must be additionally grounded if addi-
tional grounding or equipotential bond-
ing is required at the installation site.
Beware of electrical voltage
The product operates at high voltages.
Beware of hot surface
The product can get hot during opera-
tion.
Danger to life due to high voltages in the
5 min
inverter; observe a waiting time of 5 min-
utes
High voltages that can cause lethal elec-
tric shocks are present in the live compo-
nents of the inverter.
Prior to performing any work on the in-
verter, disconnect it from all voltage
sources as described in this document.
Observe the documentation
Observe all documentation supplied
with the product.
Observe the documentation
Together with the red LED, this symbol in-
dicates an error.
Inverter
Together with the green LED, this symbol
indicates the operating state of the in-
verter.
Data transmission
Together with the blue LED, this symbol
indicates the status of the network con-
nection.
Grounding conductor
This symbol indicates the position for
connecting a grounding conductor.
Alternating current
Direct current
The product is has no galvanic isolation.
Quick Reference Guide