Attachments On Request; Batteries; Battery Charger; Battery Holder Harness - Stiga BC 80 Li Gebrauchsanweisung

PROBLEM
9. Mowing is difficult
10. Grass accumulates
around the rod housing
and cutting line head
11. The line is not released
when the cutting line
head hits the ground
12. The cutting means
comes into contact
with a foreign body.
13. Excessive noise and/or
vibration is experienced
whilst working
14. The machine gives off
smoke whilst working
15. Battery power
reserve is low
16. The battery charger
is not recharging
the battery
If problems persist after having performed the above operations, contact your dealer.

15. ATTACHMENTS ON REQUEST

15.1 BATTERIES

Different capacity batteries are available to suit
specific operating requirements (Fig. 31).
The list of approved batteries for this machine
is found in the "Technical Data" table.
PROBABLE CAUSE
The cutting means is not
in good condition
Too high grass is being cut
close to the ground
The line is stuck to itself
Not enough line on the
reel or reel empty
The line is worn and too short
The line is tangled on the reel or broken Remove the line from the reel
-
Loose or damaged parts.
Machine damaged.
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
-
Proceed with cutting means
maintenance (par. 8.1)
Cut tall grass with a top down
movement to avoid accumulations.
Lubricate with silicone spray
Replace the line (chapter 8.1.3.)
Pull the line while pressing the release button
and rewind it (chapter 8.1.3)
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Optimise operations
(par. 7.2.1)
Use a second battery or
battery (par. 15.1)
Purchase a new battery
Check it is correctly inserted (par. 7.2.3)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the
battery/battery charger manual

15.2 BATTERY CHARGER

Device used to recharge the battery (Fig. 32).

15.3 BATTERY HOLDER HARNESS

This accessory is designed and built to
house the battery in a way that eases the
use of the product, reducing the overall
weight of the hand-held machine (Fig. 33).
EN - 18
REMEDY
extended