Main Components; Assembly; Assembly Components; Unpacking - Stiga BC 80 Li Gebrauchsanweisung

IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (fig.1 ):
A. Motor: drives cutting means motion via
transmission shaft and angle transmission.
B. Transmission shaft: transmits rotary
motion to angle transmission.
C. Angle transmission: final part of
the transmission shaft that transmits
motion to the cutting means.
D. Cutting means: the element
designed to cut the vegetation
1. Cutting line head: nylon
line cutting means
2. 4-point blade: metallic
disc cutting means.
E. Cutting means guard/ Additional
protection: it is a safety device
which prevents objects drawn up
by the cutting means from being
hurled away from the machine.
F. "MONO" front hand grip: semi-circular
shaped, it is used to handle the machine
and is equipped with a leg guard.
G. "MONO" rear hand grip: used to handle
the machine and equipped with the main
on/off/acceleration control buttons.
H. "DUPLEX" handle bar: "bull horn"
shaped handle bar placed crosswise
and asymmetrically to the shaft; used
to handle the machine and equipped
with the main on/off/acceleration control
buttons on the right hand side.
I. Leg guard: a safety guard that
prevents accidental contact with
the cutting means during use.
J. Harness: device made up of a
fabric belt which, placed over the
shoulders, help to support the weight
of the machine during work.
K. Connection point (of the harness): where
the harness is connected to the machine.
L. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
M. Battery: device that supplies electric current
to the tool; its specifications and regulations
for use are described in a specific manual.
N. Battery charger
upon request, paragraph
used to recharge the battery.
(accessory available
15.2): device

4. ASSEMBLY

IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the "ASSEMBLY"
section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging includes assembly components.

4.1.1 Unpacking

1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.

4.2 HANDLE ASSEMBLY

4.2.1 Assembly of "MONO" front hand grip
1. Position the front hand grip (Fig. 3.A) on the
transmission shaft (Fig. 3.B) being careful
that the protrusion (Fig. 3.C) correctly
fits into the shaft groove (Fig. 3.D).
2. Assemble the leg guard (Fig. 3.E) on the
hand grip making sure it faces left.
3. Assemble the cap (Fig. 3.F).
4. Fully tighten the screws (Fig. 3.G).
EN - 8