Klarstein 9000 BTU Bedienungsanleitung Seite 30

To get the maximum cooling efficiency, the air conditioner is designed to splash the condensation water on
the condenser coil. If the splashing sound annoys you, you can remove the rubber plug from the chassis to
lower the noise, which also cause a bit loss of performance.
Notes for installation
Remove
Before removing air conditioner to the other place, you should contact the seller first. Then it must be done
under the direction of the professional technician. In addition, the charge of this must be paid.
Noise
• Install in a location that is firm enough to avoid the enlargement of noise and vibration.
• Don't put anything in front of the outlet of outdoor unit to avoid increasing noise.
• Be sure that hot air or noise will not inconvenience neighbours.
• Please contact the seller as soon as there is strange noise during operation.
• Please use the safety support.
Electric wiring
• Must connect with ground reliably.
• The exclusive circuit must be used. But removable socket cannot be used because poor contact of it can
cause over heat or fire.
• Don't pull the power cord strongly.
• In fixed circuit, there must be electricity leakage protection switch and leakage current is less than 30 mA.
• Connecting method between air conditioners and power cord and interconnecting method of each indi-
vidual element with one another should accord with wiring diagram on the unit.
• The air conditioner should be installed in accordance with national wiring regulation.
30