Assembling The Sweeper Accessory - Husqvarna SR600-2 Bedienungsanweisung

D

Assembling the sweeper accessory

1 Press one of the drum axles (A) onto one of the two
outgoing drive shafts from the gear housing (F).
Rotate the drum axle if necessary so that the pin hole
comes over the corresponding hole in the drive shaft.
2 Fasten the roller shaft with locking pin (B).
3 Thread one of the brush drums (C) onto the fitted axle.
The end with the extended rubber lamellas is
assembled closest to the gear housing. Press in the
brush drum.
252 – English
ASSEMBLY
E
E
B
F
A
C
4 Fasten the roller on the shaft with a cotter pin (D).
Press in the end slightly when assembling.
5 Repeat these steps to assemble the axle and roller on
the opposite side. The drums are identical but must be
assembled with the extended rubber lamellas towards
the gear housing.
6 Mount the splash guard with the snap-on fasteners
(E).
7 For assembling accessories on basic machine, refer
to manual for basic machine.