Removing Nose And Ear Hair; Cutting Eyebrows - Silvercrest Z31635 Bedienungs- Und Sicherheitshinweise

Removing nose and ear hair

Note: Do not use the product if the blade
Take off the protective cap
ON / OFF switch
CAUTION! DANGER OF INJURY! Be careful not to insert the
device too deep into nose or ears. Carefully insert only the tip of the
blade into the front area of your nostril or ear. Remove the nose or ear
hair with small circular movements.
After using the trimmer, switch the device off by pushing the ON / OFF
switch downwards.

Cutting eyebrows

Select the long comb attachment
depending on the desired hair length ("Long"
length; "short"
Set the comb attachment on the blade (see fig. C). Ensure that the
comb attachment
Switch the appliance on. Move the comb in the opposite direction to
the hair growth, and from the outer tip of the eyebrow towards the
nose (see Fig. D).
To trim hair just above the skin surface, remove the comb attachment
and guide the blade
7
. Switch the device on by pushing the
1
upwards.
3
: approx. 4 mm length).
7
, fastens audibly and sits tightly.
6 7
directly over the skin in the desired area.
2
is deformed or damaged.
2
or the short comb attachment
6
: approx. 7 mm
6
7
,
6
GB 13