In the event of a power fault or system failure, you can perform the following operation for the
manual lowering of the traffic bollard:
•
Unscrew the Allen screw on the base in order to remove it from its seat.
•
Press the key under the seat of the screw using an Allen wrench. The traffic bollard lowers as
long as the key is kept pressed.
•
When the bollard is down, tighten the screw to the base.
The manual lowering device is not supplied with the FAAC CITY bollards equipped with an
automatic lowering device.
MANUAL LOWERING PROCEDURE
FAAC S.p.A. Via Benini, 1 40069 Zola Predosa Bologna (Italia) tel. +39 051 61724
- 25 -
www.faac.it