FAAC 275 H600 Bedienungsanleitung Seite 32

WARNINGS FOR THE INSTALLER – GENERAL SAFETY OBLIGATIONS
1
ATTENTION! To ensure the safety of people, it is
important that you read all the following instructions.
Incorrect installation or incorrect use of the product
could cause serious harm to people.
2
Carefully read the instructions before beginning to
install the product.
3 Do not leave packing materials (plastic, polystyrene,
etc.) within reach of children as such materials are
potential sources of danger.
4 Store these instructions for future reference.
5 This product was designed and built strictly for the
use indicated in this documentation. Any other use,
not expressly indicated here, could compromise the
good condition/operation of the product and/or be
a source of danger.
6 FAAC S.p.A. declines all liability caused by improper
use or use other than that for which the automated
system was intended.
7
Do not install the equipment in an explosive
atmosphere: the presence of inflammable gas or
fumes is a serious danger to safety.
8
For non-EU countries, to obtain an adequate level of
safety, the Standards mentioned above must be
observed, in addition to national legal regulations.
9
FAAC S.p.A. is not responsible for failure to observe
Good Technique in the installation of the FAAC CITY
products and relating accessories or for any
deformation that may occur during use.
10 Installation must be performed in compliance with
the currently Ruling Standards.
11
Before attempting any job on the system, cut out
electrical power .
12
The mains power supply of the automated system
must be fitted with an all-pole switch with contact
opening distance of 3mm or greater. Use of a
differential 6A thermal breaker with all-pole circuit
break is recommended.
13
Make sure that a differential switch with threshold of
0.03 A is fitted upstream of the system.
FAAC S.p.A. Via Benini, 1 40069 Zola Predosa Bologna (Italia) tel. +39 051 61724
- 3 -
14
Make sure that the earthing system is perfectly
constructed, and connect metal parts to it.
15
The automated system is supplied with an intrinsic
anti-crushing safety device consisting of a torque
control. Nevertheless, its tripping threshold must be
checked as specified in the Standards indicated at
point 10.
16
The safety devices (EN 12978 standard) protect any
danger areas against mechanical movement Risks,
such as crushing, dragging, and shearing.
17
Use of at least one indicator-light is recommended
for every system (i.e. flashing lamp integrated in the
bollard head), as well as a warning sign in addition
to the devices mentioned at point "16".
18
For maintenance, strictly use original parts by FAAC
S.p.A.
19
FAAC S.p.A. declines all liability as concerns safety
and efficient operation of the automated system, if
system components not produced by FAAC S.p.A.
are used.
20
Do not in any way modify the components of the
FAAC CITY automated system.
21
The installer shall supply all information concerning
manual lowering of the bollard in case of an
emergency, and shall hand over to the user the
warnings handbook supplied with the product.
22
Do not allow children or adults to stay near the
bollard while it is operating.
23
Keep radio controls or other pulse generators away
from children, to prevent the automated system from
being activated involuntarily.
24
Transit on the FAAC CITY traffic bollard is permitted
only when the automated system is idle
25
The user must not attempt any kind of repair or direct
action whatever and contact qualified personnel
only.
26 Anything not expressly specified in these instructions
is not permitted
www.faac.it