Panasonic TY-ST42PE6 Montageanweisungen Seite 17

Assembly Procedure
3. Display Overturn-Prevention
● Anchor the display to both the base and the wall surface.
 Anchoring to the base
Attach the overturn-prevention belt  (1 belt) to the pedestal using a screw  (1 screw) through the screw
hole at the rear of the pedestal, and then use a wood screw  (1 screw) to anchor the belt to the base.
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw  tightening torque: 1.2 to 1.5 N•m)
 Anchoring to the wall
Use a sturdy string, wire, or other such
commercially available item through
the hole on the display, and anchor the
string, etc., to a secure wall or pillar.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall prevention
accessories.
The details in this section indicate how to reduce any damage or injury caused by this equipment
overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall
prevention accessories will be effective in all earthquake situations.
(Cont'd)
Through hole on the display
Wire (commercially available), etc.
Screw 
Wood screw 
Band 
Wire (commercially available), etc.
Surface of wall
17