Using Your Refrigerator; Control Panel; Switching On For The First Time; Temperature Display & Adjustment - Beko CBI 7702 Handbuch

5

Using your refrigerator

Control Panel

1 2
Switching on for the first
time
To switch on the appliance be sure
that the plug is inserted to the mains
and the ON/OFF switch on the
thermostat box is pushed.
If the appliance is not going to be used
for a long period of time, switch it off
from the switch on the thermostat box,
remove all food, clean it and leave the
door ajar.
Insert the plug in mains socket to
switch on. The green light (5) will light
on.
The freezer temperature is pre-set to
-18°C but can be changed by the user.
In addition, the fridge temperature is
also adjusted.
Do not load with food immediately.
The display shows fridge actual
temperature up to 19°C.
The display shows freezer actual
temperature.
3 4
15
5 6
The appliance incorporates a
protection device in the electronics,
therefore the appliance may not
start immediately – wait for about 6
minutes.When it starts, you will then
hear the compressor and refrigerant
gas flows (You may also hear some
cracking / popping sounds which is
normal).
The set temperature will not be
reached for approximately 8 hours
and the display may fluctuate during
this period. This is not a fault. When
the correct storage temperatures have
been reached (approximately 8 hours),
you can start loading food.
When the fridge door is opened the
interior light will come on.
The front edges of the cabinet are
designed to avoid condensation and
may feel warm to the touch.
Temperature display &
adjustment
Operating temperatures are controlled
by the electronical thermostat knobs
and may be set any position between
MIN and MAX (coldest position)
a) Fridge
The display (7) shows average
temperature in fridge compartment.
EN
7