Beko CBI 7702 Handbuch Seite 16

The fridge temperature will display
from –5 to +19°C with respect to
internal temperature.
The average temperature inside the
fridge should be around +4°C (+41°F).
b) Freezer
The display shows the actual
average temperature in the freezer
compartment.
The set temperature will not be
reached for approximately 8 hours and
the display may fluctuate during this
period. This is not a fault.
To display the currently set freezer
temperature, turn the freezer knob (2).
The new freezer set temperature will
flash (3)
Freezer temperature will display from
–30 to +30°C with respect to internal
temperature.
The average temperature inside the
freezer should be equal or colder than
-18°C (0°F)
IMPORTANT: When you changed
the freezer set temperature, with for
approximately 8 hours to allow the
freezer compartment to reach and
maintain to new setting.
Door left alarm:
If the fridge door is left open for longer
than 1 minute, an audible alarm will
sound to alert you to close the door as
soon as possible. To switch it off close
the door.
High freezer temperature warning
light (RED) (6)
If the freezer temperature becomes too
high, then the warning indicator light
(6) will flash.
If the red indicator (6) remains on more
than 12 hours, please contact with
your service agency.
Don't worry if the red indicator light
comes on briefly. It could be due to
warm food storage or warm air in the
freezer compartment or if the freezer
door has been left open for long
periods.
Fast freeze function:
The fast freeze function enables you to
load fresh food to be frozen.
When you press fast freeze button (1),
the orange indicator light (4) will go on
and the compressor will run for about
24 hours.
To cancel, press fast freeze button
again and the orange light will go out.
Fast freeze will cancel itself
automatically after 24 hours, if you do
not cancel it manually.
The electronic control system
incorporates a safety protection
device so that if the fast freeze button
(1) is pressed more than once, the
compressor will not come on. Wait for
about 10 minutes and try again.
Self diagnostic:
Your appliance incorporates a self-
diagnostic system. Certain characters
(E0, E1, etc.) will be displayed where
the freezer temperature is usually
shown. During this time red light (6)
will flash. Please first see "trouble
shooting" section and then "Service"
section for further information.
16
EN