Clean The Collection Bag; Clean A Blocked Tube / Impeller; Transportation And Storage; Move The Machine - GreenWorks GD40BV Bedienungshandbuch

EN
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
5.2

CLEAN THE COLLECTION BAG

• Wear safety glasses and a dust mask.
• If it is necessary, clean the bag 1 time a year or
more.
1. Remove the bag.
2. Turn the bag inside out.
3. Hang the bag up and clean it.
4. Hang the bag to dry.
5. Turn the bag right-side out and install it again.
5.3 CLEAN A BLOCKED TUBE /
IMPELLER
1. Wait until the machine fully stops.
2. Remove the blower tube or mulcher tubes and the
bag.
3. Remove the material that causes a blockage of the
tube or impeller.
4. Make sure that the impeller has no damage.
5. Turn the impeller with the hand to make sure that
there is no blockage.
6. Install the blower tube or mulcher tubes and the
bag.
Avoid the intake of large objects that could damage
the impeller.
6 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
6.1

MOVE THE MACHINE

• Only hold the machine with the handgrip.
6.2

STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
WARNING
WARNING
English
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
7

TROUBLESHOOTING

PROBLEM POSSIBLE
CAUSE
The tube has
blockages.
The impeller has
blockages.
The bag is full.
The bag is dirty.
The ma-
The bag has
chine does
damage.
not blow or
mulch.
The bag is unzip-
ped.
The battery pack
is not secure.
The battery ca-
pacity is low.
The on/off button
is in the OFF po-
sition.
The on/off button
is defective.
The ma-
The tube is not in-
chine does
stalled correctly.
not start.
The gate is not
locked.
The battery pack
is not secure.
The battery ca-
pacity is low.
6
SOLUTION
Make sure that the
tube is clear.
Make sure that the
impller is clear.
Empty the bag.
Clean the bag.
Replace the bag.
Lock the bag.
Make sure that you
latch the battery
pack correctly.
Charge the battery
pack.
Push the on/off but-
ton.
Replace the defec-
tive parts by an ap-
proved service cen-
tre.
Make sure that you
install the tube cor-
rectly.
Make sure that you
lock the gate.
Make sure that you
latch the battery
pack correctly.
Charge the battery
pack.