Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks GD24X2BV Bedienungshandbuch

2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
4. Do the same operation with the other battery pack.
Optimize the power and performance of your new
2x24V machine by running with both battery packs
charged to 100%. If each battery has a different charge
state, the run-time of the machine is subject to the lowest
powered battery (For example: one battery is charged
100%, and the other is charged 50%, the unit will only
run until the 50% battery is depleted).
3.5

REMOVE THE BATTERY PACK

Figure 10.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

4.1

START THE MACHINE

Figure 11.
1. Push the on/off button in the on position.
2. Turn the speed dial forward to increase speed.
4.2

STOP THE MACHINE

Figure 11.
1. Push the On/off button.
4.3

OPERATION TIPS

• Make sure that the machine is in good condition.
• Make sure that the tubes and guards are in position.
• Do not point the machine at the person or loose materials
before you start the unit.
• Ear protection is necessary to decrease the risk of hearing
loss related to noise level.
• Obey all applicable laws, regulations, standards and
ordinances.
4.4

OPERATE AS A GARDEN VAC

Figure 12.
1. Hold the machine tightly.
2. Hold the machine in a way the suction pipe is slighty
tilted 5 - 10 cm above the floor.
3. Use a sweeping action to collect light unwanted
materials.
NOTE
Make sure that you install and zip the bag.
NOTE
English
Use the shoulder strap.
4.5

OPERATE AS A BLOWER

1. Hold the machine tightly.
2. Operate from side to side.
3. Move the machine forward slowly.
4. Keep the collected unwanted materials in front of you.
Use rakes and brooms to loosen the unwanted material
before you blow.
Use the low speed to move dry items, and high speed to
move heavy items such as large unwanted materials or
gravel.
5

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1

CLEAN THE MACHINE

The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
5.2

CLEAN THE COLLECTION BAG

• Wear safety glasses and a dust mask.
• If it is necessary, clean the bag 1 time a year or more.
1. Remove the bag.
2. Turn the bag inside out.
5
NOTE
NOTE
NOTE
CAUTION
CAUTION
WARNING
CAUTION
EN