Operation; Start The Machine; Stop The Machine; Led Diagnostics - GreenWorks GD40BV Bedienungshandbuch

4

OPERATION

WARNING
Make sure the blower tube is in position before
operation.
4.1

START THE MACHINE

Figure 11.
1. Push the On/off button.
2. The machine starts in a low speed.
3. Turn the speed dial forward to increase the speed
from 110 km/h to 210 km/h.
4. Push the speed button to increase the speed from
130 km/h to 280 km/h.
IMPORTANT
Set the speed to high position when the machine is in
the mulching mode.
4.2

STOP THE MACHINE

Figure 11.
1. Push the On/off button.
4.3

LED DIAGNOSTICS

CONDITION LED
Low voltage 1 LED flashes
protection red 5 times.
Over-load pro- 1 LED flashes
tection red 4 times.
The green and
Battery jam
red LED go off.
protection
The unit stops.
Unusual bat-
The green and
tery tempera-
red LED go off.
ture
4.4

OPERATION TIPS

• Make sure that the machine is in good condition.
• Make sure that the tubes and guards are in position.
• Do not point the machine at the person or loose
materials before you start the unit.
• Ear protection is necessary to decrease the risk of
hearing loss related to noise level.
• Obey all applicable laws, regulations, standards and
ordinances.
English
SOLUTION
Start the machine
again or Charge the
battery pack.
Start the machine
again.
Remove the battery
pack for 5 seconds
to set the machine.
When the tempera-
ture of the battery
pack decreases, the
machine can oper-
ate in a good condi-
tion.
5
4.5

OPERATE AS A MULCHER

Figure 12.
1. Hold the machine tightly.
2. Tilt the mulcher tubes (2 - 4 in. or 5 - 10 cm).
3. Use a sweeping action to collect light unwanted
materials.
NOTE
Make sure that you install and zip the bag.
NOTE
Use the shoulder strap.
4.6

OPERATE AS A BLOWER

1. Hold the machine tightly.
2. Operate from side to side.
3. Move the machine forward slowly.
4. Keep the collected unwanted materials in front of
you.
NOTE
Use rakes and brooms to loosen the unwanted
material before you blow.
NOTE
Use the low speed to move dry items, and high speed
to move heavy items such as large unwanted
materials or gravel.
5

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
5.1

CLEAN THE MACHINE

CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
EN