Clean The Machine; Store The Machine; Troubleshooting; Technical Data - GreenWorks G40TL Bedienungshandbuch

EN
5.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
6

STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
7

TROUBLESHOOTING

Problem
The motor shuts
down whilst work-
ing.
The machine
smokes during op-
eration.
Motor runs but
tines do not move.
WARNING
Possible cause Solution
Make sure that
The battery pack is you tighlty instal-
not installed tight- led the battery
ly. pack in the ma-
chine.
The battery pack is Charge the battery
out of power. pack.
The machine has Do not use the ma-
damage. chine and speak to
service center.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The tines are
then clear block-
blocked.
age from the tines.
Speak to service
Gear train failure.
center.
English
8

TECHNICAL DATA

Voltage
No load speed
Cultivating path
Protection degree
Weight (without battery pack)
Measuered sound pressure level
Guaranteed sound power level
Vibration
Uncertainty
Battery model
Charger model
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Riggaregatan 53, 211 13 Malmö, Sweden
Name and address of the person authorised to compile the
technical file:
Name: Peter Söderström
Address: Riggaregatan 53, 211 13 Malmö, Sweden
6
40V
200 (±10%) RPM
8'' (20 cm)
IPX1
12 kg
L = 80 dB(A) ,
PA
K = 3 dB(A)
PA
L = 93 dB(A)
WA.d
2
2.36 m/s
2
K = 1.5 m/s
G40B2/G40B25/
G40B4/G40B5/
G40B6 and other
BAF series
G40C and other
CAF series