Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - GreenWorks 4700407 Bedienungshandbuch

Open the battery door to get the accessory.
To remove the hose, turn the locking end of the hose
counter-clockwise.
3.5

INSTALL THE BATTERY PACK

See figure 7
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
3.6

REMOVE THE BATTERY PACK

See figure 7
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
4

OPERATION

WARNING
Do not handle battery pack, switch, or machine with wet
hands. Do not expose to rain or allow liquid to enter the
motor compartment.
4.1

START THE MACHINE

See figure 8
1. Push the on/off button to turn the machine on.
WARNING
Hold the machine with one hand during operation.
4.2

STOP THE MACHINE

1. Set the ON / OFF switch to the off position.
NOTE
NOTE
English
4.3

BLOWING FEATURE

See figure 9
The wet/dry vac can blow sawdust and other debris.
Complete the steps below to use your machine as a blower.
1. Align either of the grooves in the blowing port with the
tabs on the hose.
2. Insert the hose into the blowing port.
3. Attach the desired accessory to the end of hose.
4. Start the machine.
4.4

OPERATION TIPS

• The filter must always be in correct position to avoid
leaks and possible damage to the machine.
• When you use your machine, it will be necessary for you
to empty the collection tank and clean the filter at
frequent intervals to maintain peak vac performance.
• When the liquid in the collection tank reaches a
predetermined level, the float mechanism will rise
automatically to cut off air-flow. This will cause the
suction stop and the higher motor noise. When this
happens:
1. Turn off the machine.
2. Remove the battery pack.
3. Empty the collection tank.
• Dry the filter after you use the machine to avoid mildew
and damage to the machine.
5

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1

CLEAN THE FILTER

Allow the filter to dry before storing the machine or picking
up debris.
Clean the wet/dry vac filter frequently to maintain optimal
performance.
Cleaning a dry filter:
5
CAUTION
CAUTION
WARNING
NOTE
EN