Operation; Start The Machine; Stop The Machine; Operation Tips - GreenWorks GD60BPB Bedienungshandbuch

3.6 INSTALL THE BATTERY PACK
Figure 11.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.7 REMOVE THE BATTERY PACK
Figure 11.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.8 ADJUST THE HARNESS
Figure 12 -15.
1. Fit the backpack on your back.
2. Pull the ends of the straps down to tighten the harness.
3. Connect the horizontal chest strap.
4. Pull the end of the chest strap to tighten.
5. Lift the tabs of the adjusters to loosen the straps.
6. Lock the quick-release fastener by pushing it together.
7. Squeeze the hooks to open the quick-release fastener.
Install the back pad against your back tightly and safely.
3.9 REMOVE THE HARNESS
1. Open the quick-release fasteners on the chest strap.
2. Loosen the harness straps by lifting the sliding adjusters
and then take off the machine.
WARNING
In the event of imminent danger, quickly remove the
machine. Release the chest strap before you put the machine
on the ground.
4

OPERATION

WARNING
Make sure the blower tube is in position before operation.
NOTE
English
4.1

START THE MACHINE

Figure 1.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
4.2

STOP THE MACHINE

Figure 1.
1. Release the trigger to stop the machine.
Wait until the engine stops after you stop the machine.
4.3 CRUISE CONTROL LEVER
Figure 1.
1. Pull the cruise control lever clockwise to increase the
speed. This will lock the speed at the desired setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
If you decrease the speed all the way, the unit will stop and
it is necessary to do the first step again.
4.4 TURBO BUTTON
Figure 1.
1. Push the turbo button, the machine is at the highest speed.
2. Release the turbo button, the machine is at the normal
speed.
4.5 OPERATE THE MACHINE
Figure 16.
1. Hold the machine tightly with one hand.
2. Blow from side to side with the nozzle above the ground.
3. Move forward slowly.
Keep the unwanted materials in front of you
Move heavier materials at a high speed while lighter
materials at a low speed.
4.6

OPERATION TIPS

• Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
• Use rakes and brooms to clear the unwanted material
before you blow.
5
NOTE
NOTE
NOTE
NOTE
EN