Zanussi ZFU20200WA Benutzerinformation Seite 11

Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on the op-
posite side.
• Unscrew and remove the lower hinges. (3)
• . Remove the door.
3
2
1
• Unscrew the upper pin (1) and place it on the
opposite side. (2)
• Refit the door.
2
1
www.zanussi.com
• Stand the appliance upright.
• Unscrew the handle (1) and fix it on the op-
posite side (2).
• Re-insert the cover pins (3) on the opposite
side.
1
2
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the
side edge of the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow
back in the compressor.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
3
11