Technical Specifications - Vitek VT-2509 Y Die Betriebsanweisung

Styling
Start styling from the upper side of the head.
Remember that hair should be dried from the
roots; before starting to dry the next lock, make
sure that you have dried the previous lock from
roots to tips.
Overheating protection
This unit has automatic protection from overheat-
ing that will switch it off if the outgoing air is too
hot. If the unit has been switched off during oper-
ation, switch it off by setting the switch (3) to the
«0» position and unplug the unit; provide that the
air inlets and outlets are unblocked and let the
unit cool off for 10-15 minutes; after that you can
switch it on again. Do not block the air openings
during operation of the unit and avoid getting of
hair into the air inlet grid (5) openings.
CLEANING AND CARE
• Before cleaning, unplug the unit and let it cool
down completely.
•
Do not immerse the unit, the power cord and
the power plug into water or any other liquids.
•
Do not use detergents, abrasives and any sol-
vents to clean the unit.
•
Clean the unit body with a soft, slightly damp
cloth and then wipe it dry.
•
You can wash the attachments with warm
water. Always dry the attachments before
installing.
STORAGE
•
Let the unit cool down completely and clean it
before taking away for storage.
•
Do not wind the power cord around the unit
body as this can damage the cord.
VT-2509.indd 5
•
For easy storing there is a hanging loop (6),
you can store the unit by means of this loop
provided that no water gets on the unit in this
position.
• Keep the unit away from children in a dry cool
place.
DELIVERY SET
Hot air styler – 1 pc.
Nozzle – 1 pc.
Attachment comb – 1 pc.
Brush-attachment – 2 pc.
Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220-240 V ~ 50/60 Hz
Power: 1200 W
The manufacturer preserves the right to change
the specifications of the unit without a prelimi-
nary notification.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
5
ENGLISH
19.09.2014 12:57:52