Cleaning And Care; Delivery Set; Technical Specifications - Vitek VT-2510 BW Die Betriebsanweisung

•
Place the unit on a flat heat-resistant sur-
face using the base (6) and let it cool down
completely.
•
To remove the attachment, press the
attachment release button (5) and turn the
attachment counterclockwise.
Overheating protection
Overheating protection switches the hot air sty-
ler off if the outgoing air is too hot. If the hot air
styler is switched off during operation, set the
switch (3) to the «0» position, unplug the unit
and make sure that the inlets and outlets are
unblocked. Let the unit cool down for 5-10 min-
utes and switch it on again. Do not block the
air inlets during the hot air styler operation and
avoid getting of hair into its air inlet.

CLEANING AND CARE

The hairdryer is intended for household usage
only.
•
Set the switch (3) to the «0» position, dis-
connect the hot air styler from the mains
and let it cool down. To remove the attach-
ment, press the attachment release but-
ton (5) and turn the attachment counter-
clockwise.
•
Wipe the unit body with a damp cloth and
then wipe it dry.
•
Clean the air inlet grid (9) with a brush.
•
Never immerse the unit into water or other
liquids.
•
Do not use abrasives and solvents to clean
the unit body.
STORAGE
•
Disconnect the unit from the mains and
clean it.
•
Never wind the power cord around the hot
air styler, as this may damage the unit.
T-2510_105 x148.indd 5
Handle the power cord with care, do not
pull, twist or stretch it, especially near
the power plug or at the junction point.
Straighten the cord periodically if it gets
twisted during the hot air styler operation.
•
Keep the unit away from children in a dry
cool place.

DELIVERY SET

Hot air styler – 1 pc.
Round brush – 1 pc.
Flat brush – 1 pc.
Nozzle – 1 pc.
Manual – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 230 V ~ 50/60 Hz
Power consumption: 1000 W
The manufacturer preserves the right to
change the specifications of the units without
a preliminary notification
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can
be obtained from the dealer from whom the
appliance was purchased. The bill of sale or
receipt must be produced when making any
claim under the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 2004/108/ЕС
and to the Low Voltage Regulation
(2006/95/ЕС )
5
ENGLISH
18.03.2016 15:40:08