Sanus VMAA18 Montageanleitung Seite 7

Seite von 65

/ 65
Lesezeichen

Verfügbare Sprachen

Step 4: Attach the Arm Assembly (Continued)

CAUTION: The 1" Diameter Tubes (D) must extend beyond the outside edges of both Monitor Brackets (E) and the Allen Bolts in all six

Vise Assemblies (F) must be tightened. Failure to do this will result in an installation that is unstable and may result in property damage

and/or personal injury.

Position the Arm Assembly (B) so that the hook shaped tab shown in the Detailed View of Diagram 4b is on the top. Line up the two 1" diameter

holes in the Monitor Bracket (E) at the other end of the Arm Assembly with the 1" Diameter Tubes (D). Continue to push the 1" Diameter Tubes

through the bracket on the Arm Assembly and then through the other Monitor Bracket. Again, make sure the Vise Assemblies (F) on both the Arm

Assembly and the second Monitor Bracket are oriented so that the 1" Diameter Tubes will pass between the jaws.

NOTE: Do not over-tighten the Vise Assembly (F), or the two Vise Assemblies in the Arm Assembly (B). When tightening the Vise

Assemblies, turn the Allen Bolt in until resistance is felt; then, tighten the Allen Bolt approximately 1 & 1/2 turns or until the head of the

Allen Bolt is slightly above the surface of the Vise Assembly. The 1" Diameter Tubes (D) must not be able to move from side-to-side when

the Vise Assembly is properly tightened.

Once the 1" Diameter Tubes are in place, tighten the allen bolts on the four Vise Assemblies in the two Monitor Brackets with the 3/16 Allen Key

(K) to lock the television to the mount. Next, slide the Arm Assembly into the desired position between the two Monitor Brackets (Sanus recom-

mends the Arm Assembly be centered between the Monitor Brackets) and tighten the two remaining Allen Bolts in the Vise Assemblies inside the

Arm Assembly.

Step 5: Attach the Wall Plate: Wood Stud installation only.

CAUTION: Do not over tighten the Lag Bolts. Tighten Lag Bolts (I) only until the Lag Bolt Washer (J) is pulled firmly against the Wall

Plate (A). If there is a layer of drywall or other material, this drywall or other material may not exceed 5/8 inch [15.8 mm] in thickness.

Failure to heed this caution may result in property damage and/or personal injury.

The Wall Plate (A) must be mounted to two wood studs at least 12 - 16 in. apart. Use a high quality stud sensor to locate two adjacent studs. It is a good

idea to verify where the studs are located with an awl or thin nail. Pre-drill a 2.5" deep hole in each stud at the desired height using a 3/16" drill bit.

Make sure these holes are in the center area of the studs and level with each other. Use the Wall Plate as a template to mark the location of the

second hole in each stud. Drill 2.5" deep holes using the 3/16" drill bit in each marked location. Attach the Wall Plate to the wall using four Lag Bolts

(I) and four Lag Bolt Washers (J). Make sure the Wall Plate is oriented so the flat surface in the center of the plate is against the wall as shown in

Diagram 5.

6901-100016_ML.indd 8

Diagram 4b