Herunterladen Diese Seite drucken

Sanus VMAA18 Montageanleitung Seite 2

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 18
Thank you for choosing a Sanus Systems VisionMount™ wall mount. This model will hold 30 - 50 inch Plasma or LCD TVs weighing up
to 130 lbs to a vertical wall. It is a full motion mount that allows you to tilt the television from +5° to -15°, swivel to ±90°, and roll ±6°.
CAUTION: The size and weight of your large screen television must not exceed 50" [1270 mm] diagonally and 130 Lbs [59
Kg]. The wall must be capable of supporting five times the weight of the television plus the wall mount. Never use defective
parts. Improper installation may cause property damage or personal injury. Do not use this product for any purpose that is not
explicitly specified by Sanus Systems.
If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor
or contact Sanus at 800.359.5520 or www.sanus.com. Our customer service representatives can quickly assist you with installation
questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly
to you. Check carefully to make sure that there are no missing or defective parts. Sanus Systems can not be liable for damage or injury
caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of
purchase.
NOTE: This mount is not intended for use on brick, concrete block, concrete, or steel stud walls. Typical wall anchors do not
have sufficient holding power to support this mount. It is up to the installer to verify the safety of any installation method
or hardware that is not provided by or recommended by Sanus Systems. Sanus makes every effort to assure all necessary
television mounting hardware is included. If the hardware you need is not included please consult your local hardware store or
call Sanus Systems.
Required Tools: 3/16" drill bit, drill, adjustable or crescent wrench, phillips screw driver
Supplied Parts: (Some parts are not shown at same scale)
Wall Plate - A
Qty. 1
1" Diameter Tube - D
Qty. 2
Sanus Systems 2221 Hwy 36 West. St. Paul, MN 55113 07.18.06 (6901-100016)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
6901-100016_ML.indd 3
6901-100016_ML.indd 3
Assembly Instructions for Model: VMAA18
Arm Assembly - B
Qty. 1
Monitor Bracket - E
Qty. 2
Preventor - C
Qty. 1
Vise Assembly - F
Qty. 4
10/27/06 9:03:52 AM
10/27/06 9:03:52 AM

Werbung

loading