Swagelok Series 5 Bedienungsanleitung Seite 30

30 Series 5 Weld Head User's Manual
5. Remove the weld head housing screws from the housing.
Using a slight rocking motion, carefully separate the locking
ring half of the weld head housing from the motor half. See
Figure 32.
6. Carefully separate the weld head housing halves so that
internal components are not damaged. See Figure 32.
7. Remove the rotor from the motor half of the weld head
housing. See Figure 33.
8. Carefully lift the power block subassembly out of the motor
half of the weld head housing. See Figure 34.
Weld Head
Housing
(Work side)
Weld Head Housing
Figure 32 Removing the Locking Ring
Half of the Weld Head Housing
Figure 33 Removing the Rotor
Power Block
Subassembly
Weld Head
Housing
(Motor side)
Figure 34 Removing the Power Block
Subassembly
Housing
Screws
(Motor side)
Rotor