Swagelok Series 5 Bedienungsanleitung Seite 28

28 Series 5 Weld Head User's Manual
Weld Head Daily Maintenance
Perform weld head maintenance daily and every 1,000 to 1,200
welds. Depending on usage and wear, maintenance may be
performed before the 1,000-weld mark.
At the start of each work day:
1. Inspect the weld head for cleanliness. Pay close attention to
the rotor area.
2. Press JOG. Check the rotor for smooth rotation. Press JOG
to stop the rotor motion. If the rotation is erratic or noisy,
disassemble the weld head and clean the rotor, gears, and
brush. See Weld Head Disassembly and Cleaning.
3. Press HOME to return the rotor to the HOME position.
At the end of each work day:
1. Remove dirt, carbon, and vapor deposits from the weld
head with a clean, soft cloth and a solvent such as isopropyl
alcohol.
2. Store the weld head in a clean, dry place.

WARNING!
Disconnect the WORK and
ELECTRODE cables from the
power supply before performing the
adjustment or maintenance .
Rotor area
Figure 29 Inspect Exposed Surfaces of
the Weld Head
Caution!
Do not use lubricants inside the
weld head .
Caution!
The rotor will move when JOG or
HOME is pressed . The rotor is a
potential pinch point .