3M Emphaze AEX Sicherheitsinformationen Und Installations- Und Bedienungshandbuch Seite 4

To reduce the risk of injury from possible end user exposure associated with a) biological contamination and b)
degradation products released from the purifi cation media; and
To reduce the risk of product loss associated with a) chemical release from purifi cation media, and b)
nullifi cation of Supplier's USP<88> Class VI compliance of fi lter capsule components:
• Use the installation procedure specifi ed in Operation Instructions.
• The capsule must be subjected to a preconditioning fl ush prior to use. Use the procedure specifi ed in Operation
Instructions.
2
• At least 54 L/m preconditioning fl ush volume.
• Carry out preconditioning fl ush procedures of 3M™ Zeta Plus™ capsules and 3M™ Emphaze™ AEX Hybrid Purifi er
capsules separately.
• After pre-use NaOH sanitization, fl ush the system with appropriate aqueous buff er until the pH range of 5 to 9 has
been attained and monitor the pH of the capsule effl uent to determine when the baseline should be reached (e.g., ±
0.5 pH units from the pH of the buff er used to fl ush the media).
• Capsules are designed for single use only. Do not reuse.
• Do not store capsules under conditions outside of the recommended storage temperature range.
• Do not use past the expiration date.
• Do not use with organic solvents or fl ammable liquids.
• Use only with aqueous based process fl uids in the pH range of 5 to 9.
• Do not use with or expose this product to hot liquids >40°C (104°F).
• Do not use the product on unleveled surfaces.
• Do not gamma or ethylene oxide sterilize the capsules.
• Do not steam-in-place sterilize the capsules.
• Only expose the capsule to 1 sterilization or 1 sanitization cycle prior to use.
• Do not autoclave and base sanitize the same capsule prior to use.
• Do not autoclave or base sanitize capsules with the following part numbers BV8 Luer (EMP301AEX020A) and BV8
Sanitary (EMP303AEX020A).
WARNING
- 2 -