Sony BKM-B30NW Bedienungsanleitung Seite 51

Setting up the network configuration
Setting up the network configuration, such as IP
address setting, is necessary for building a LAN
connection. The IP address of the Display (Network
Adaptor) will be displayed on the task bar of the Start
up and the Desktop windows of the Display.
If the connection environment is changed, you need to
set up the network configuration again.
For details, contact your network administrator.
1
Click Desktop View in the Start up window.
2
From the Start menu, click Control Panel in the
Desktop window.
3
Double-click the Network icon.
The Network Configuration dialog box appears.
4
Select the driver name according to the network
connection type.
You can select one of the following driver names.
NE2000 Compatible Ethernet Driver: When
using the recommended NE2000 compatible PC
LAN card.
Wireless Ethernet Driver: When using the
specified wireless LAN PC card.
On-board LAN: When using the ETHER
connector to connect to LAN.
The selected driver's setting dialog box appears.
5
Confirm that the "Specify an IP address" radio
button is selected, and set the necessary items.
The IP Address is initially set to "192.168.0.1,"
and the Subnet Mask is set to "255.255.0.0" at the
factory.
'Wireless Ethernet Driver' settings
IP Address Name Servers
An IP address can be
automatically assigned to this
computer. If your network
does not automatically assign
IP Address:
IP addresses, ask your network
administrator for an address,
_
Subnet Mask:
and then type it in the space
provided.
Default Gateway:
_
Obtain an IP address via DHCP
_
Specify an IP address
_
1 9 2 . 1 6 8 . 0 . 1
2 5 5 . 2 5 5 . 0 . 0
_ . . .
6
Click the Name Servers tab to display the Name
Servers dialog box, then set the necessary items.
'Wireless Ethernet Driver' settings
IP Address Name Servers
Name server addresses may be
automatically assigned if DHCP
is enabled on this adapter.
You can specify additional
WINS or DNS resolvers in the
space provided.
7
Click the OK button.
The Network Configuration dialog box reappears.
8
According to your requirements, click the
Identification tab and set the necessary items.
9
Click the OK button.
When you use a wireless LAN PC card
If you select Wireless Ethernet Driver in step 4, follow
the steps below after performing step 7.
1
Click the On-board LAN tab.
2
Remove the check from the "Enable On-board
LAN" checkbox.
3
Click the OK button.
The window in step 3 reappears.
Note
Once the On-board LAN was deactivated, it is not
shown in the driver names of the Network
Configuration dialog box. If you want to select On-
board LAN, check the Enable On-board LAN
checkbox, then repeat from step 3 in "Setting up the
network configuration."
_
Primary DNS:
. . .
_
Secondary DNS: . . .
_
Primary WINS: . . .
_ . . .
Secondary WINS:
11
(GB)