Herunterladen Inhalt Inhalt Diese Seite drucken

Using The Remote Controller - Panasonic CS-ME7NKE-Y Installationsanleitungen

Mit split-system
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 222

USING THE REMOTE CONTROLLER

HOW TO INSTALL BATTERIES
ACL button
1.
Slide the cover in the direction indicated by the arrow and
remove it.
2.
Install two AAA alkaline batteries. Make sure the batteries point
in the direction marked in the battery compartment.
3.
Use a thin object such as the tip of a pen to press the ACL
button.
• The batteries last about six months,
CAUTION
depending on how much you use the
remote controller. Replace the
batteries when the remote
controller's display fails to light, or
when the remote controller cannot
be used to change the air
conditioner's settings.
• Use two fresh leak-proof type-AAA
alkaline batteries.
• In replacing batteries, follow the
instructions as mentioned in the
sub-section "HOW TO INSTALL
BATTERIES".
• If you do not use the remote
controller more than 1 month, take
out the batteries.
HOW TO REMOVE BATTERIES
Slide the cover in the direction indicated by the arrow and remove
it, and then remove the batteries.
Dispose of the used batteries at the
CAUTION
designated location in compliance with
the applicable local ordinances.
10
HOW TO USE THE REMOTE CONTROLLER
When using the remote controller, always point the unit's
transmitter head directly at the air conditioner's receiver.
Air Conditioner
(Indoor unit)
Remote Controller
REMOTE CONTROLLER INSTALLATION
POSITION
The remote controller may be operated either from a non-fixed
position or from a wall-mounted position. To ensure that the air
conditioner operates correctly, do not install the remote controller
in the following places:
• In direct sunlight
• Behind a curtain or other places where it is covered
• More than 8 m away from the air conditioner
• In the path of the air conditioner's airstream
• Where it may become extremely hot or cold
• Where it may be subject to electrical or magnetic noise
• Where there is an obstacle between the remote controller and air
conditioner (since a check signal is sent from the remote
controller every 5 minutes)
MOUNTING THE REMOTE CONTROLLER
Before mounting the remote controller, press the ON/OFF
operation button at the mounting location to make sure that the air
conditioner operates from that location. The indoor unit should
make a beeping sound to indicate that it has received the signal.
Remote Controller Holder
Press
Set in
place
Mounting Screws
4 x 16 (included)
• To prevent loss of the remote
controller, you can connect the
remote controller to the holder by
passing a string through the remote
controller and attachment hole.
To take out the remote controller, pull it forward.
WHEN HOLDING THE REMOTE CONTROLLER
• When using the remote controller and during air conditioner
operation, the transmitter on the remote controller should be
pointed towards the receiver on the indoor unit.
• Make sure that there are no objects between the remote
controller and receiver which could block the signal.
Receiver
(Transmitter head)
Rear Side
Hole

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis