How To Install The High-Spec Wired Remote Controller (Optional Part); Installation Location; Mounting - Panasonic S-80MW1E5 Installationsanleitung

6. HOW TO INSTALL THE HIGH-SPEC WIRED REMOTE CONTROLLER (OPTIONAL PART)

6-1. Installation Location

● I nstall at the height of 1 to 1.5 m from the floor (Location where average
room temperature can be detected).
● Install vertically against the floor.
● W hen installing more than 1 remote controller next to each other, keep
distance of 5 mm on the right and left and 50 mm on top and bottom.
● Avoid the following locations for installation.
• By the window, etc. exposed to direct sunlight or direct air
• In the shadow or backside of objects deviated from the room air flow.
• L ocation where condensation occurs. The remote controller is not
moisture proof or drip proof.
• Location near heat source
• Uneven surface
● K eep distance of 1 m or more from the TV, radio and PC. (Cause of fuzzy
images or noise)
NOT E
● B e careful not to connect cables to other terminals of indoor units
(e.g. power source wiring terminal). Malfunction may occur.
● D o not bundle together with the power source wiring or store in the same
metal tube. Operation error may occur.
● If noise is induced to the unit power supply, attach a noise filter.

6-2. Mounting

1. Remove the bottom case.
Bottom
case
2. Mount to the wall.
T here are two types of mounting: Exposed type and
Embedded type for the wired remote controller. See
the next page for the details.
N OTE
Mounting the bottom case
● T ighten the screws securely until the
screw heads touch the bottom case.
Insert the
Otherwise, loose screw heads may hit
screwdriver and
the PCB and cause malfunction when
slightly turn.
mounting the top case.
● D o not over-tighten the screws.
Flat-blade
screwdriver
The bottom case may be deformed,
resulting in fall of the unit.
Connecting the remote control wiring
● A rrange the wires as shown in the
illustration for 2 in step 2, avoiding unnecessary wires being stored
in the remote controller case.
Caught wires may destroy the PCB.
● A void wires touching parts on the PCB.
Caught wires may destroy the PCB.
17
5 mm or more
50 mm or
more
1 to 1.5 m
Floor