This model adopts different iPod/iPhone models. Following steps guide you listening to iPod music.
1. Slide the "iPod/iPhone tilt angle slider" for the "iPod/iPhone tilt angle lever" to tilt at a desired angle,
if apply. Recommend to lay down the iPod/iPhone during the unit transportation.
2. Your iPod/iPhone can now be inserted into the docking port by placing the connector on the bottom
of the iPod/iPhone onto connector in the docking bay.
Caution: Please be careful when seating the iPod/iPhone into the docking to avoid damaging the
30-pin connector on the iPod/iPhone or in the docking system.
3. Slightly push the iPod/iPhone to a desired tilt angle, if necessary.
4. Press the
button from the main unit or the STANDBY
to turn on the unit and the power status indicator lights on.
5. Press the FUNC button from the main unit or the iPHONE button from the remote control to select
iPod/iPhone mode, where the iPhone indicator will display.
Operation
- To start playback music, press the
- To pause the music, press the
- To resume music, press the
- You may press the VOLUME +/- button to adjust the volume to a desired level.
Note: The volume level cannot be adjusted using the volume control on your iPod / iPhone after being
docked.
Following operation can be implemented from the remote control:
- To skip to next or previous song, press the
- To set iPod music play-mode in random, press the
- To set iPod music in repeat play-mode, press the
- To mute the volume, press the MUTE button. Press the MUTE button again to resume listening the
music.
6. To turn off the unit, press the
remote control and the power status indicator will light off.
Note:
- When the unit is powered by external DC adaptor and once the iPod/iPhone connected to the
docking station, the unit recharges the iPod/iPhone battery.
- Once the iPod/iPhone is inserted, the unit will switch to iPod/iPhone mode automatically and neglect
the current mode.
Listening to iPod / iPhone
button once.
button.
button again.
/
button.
button.
button from the main unit or the STANDBY
8
button from the remote control
button.
button from the