Herunterladen Inhalt Inhalt Diese Seite drucken

Radio Tuner Operation - LENCO IPD-5300 Handbuch

Tragbares radio mit ipod/iphone-dockingstation
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

FM Antenna
Fully extend the FM rod antenna for the best FM radio reception.
Radio Tuning
1. Press the
button from the main unit or the STANDBY
on the unit, where the power status indicator light on.
2. Press the FUNC button from the main unit or the RADIO button from the remote control to select FM
radio mode. You may press the ST/MO button from the remote control to select FM stereo or mono
radio reception, if necessary.
3. To manually tune to a desired station, repeatedly press the TUNE + / - button.
4. To automatically search for stations with strong signals, long press the TUNE + / - button until the
frequency digits on display begins to scan then release the button. The tuner will stop on the
first strong signal it finds.
Note:
- Manual tune to select weaker stations that might be skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency of the station, for example , it stops on
100.9 MHz instead of 100.8 MHz, use the manual tuning method to "fine tune" to the exact frequency
of the desired station.
Radio Preset Stations
The unit allows you to store up to 20 FM stations for easy recall at any time.
Preset Stations
1. Press the
button from the main unit or the STANDBY
on the unit, where the power status indicator light on.
2. Press the FUNC button from the main unit or the RADIO button from the remote control to select FM
radio mode.
3. Tune the radio station you want to store in memory by using the TUNE + / - button.
4. Press the MEM button. The preset channel number appears on display and blinking.
5. To select desired preset station number, press the CH + / - button.
6. To confirm preset location, press the MEM button.
7. Repeat steps 3 to 6 to store other stations, if apply.
Note :
1. There is a few seconds delay when programming, after this delay time, the unit will automatically
switch back to normal tuner mode.
2. You can overwrite a preset station by overwriting and storing the new frequency in its place.
Recalling Preset Station
1. Press the
button from the main unit or the STANDBY
on the unit, where the power status indicator light on.
2. Press the FUNC button from the main unit or the RADIO button from the remote control to select FM
radio mode.
3. To select desired preset station, press the CH + / - button.

Radio Tuner Operation

9
button from the remote control to turn
button from the remote control to turn
button from the remote control to turn

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis