Listening To External Audio Source; Clock Setting; Alarm Operation - LENCO IPD-5300 Handbuch

1. Connect an audio cable (not included) with 3.5mm stereo plug from an auxiliary audio device to
the AUX jack of the unit.
2. Press the button from the main unit or the STANDBY
turn on the unit.
3. To select auxiliary audio input, press the FUNC button from the main unit or the AUX button from
the remote control. The "AUX" indicator shows on display.
4. Turn on the external auxiliary audio device.
5. The volume and Bass / Treble level can now be controlled through the unit.
Operate all other functions on the external device as usual.
Notes: Press the button from the main unit or the STANDBY
control to turn off the unit when you finish listening.
Don't forget to switch off the power of the external audio device as well.
When the unit is OFF (power off mode):
Note: Following settings are implemented from the remote control.
Set 12/24 Hour format
1. Press the SET button entering 12/24 hour format setting mode.
2. Press the Up / Down
Set Clock
3. Press the SET button again and the clock digits blink.
4. Press the HR button to set hour.
5. Press the MIN button to set minute.
Exit setting mode
To save all settings and auto-exit the setting mode, wait for a few seconds.
Note: Following settings are implemented from the remote control.
When the unit is OFF (power off mode):
Set the alarm time
1. Press the ALARM SET button and the alarm time digits and alarm indicator
2. Press the HR button to set alarm hour.
3. Press the MIN button to set alarm minute.
Select wake up alarm source
4. Press the ALARM SET button again, alarm source indicator blink.
5. Press the Up / Down
(iPhone/iPod).
Save settings and activate alarm
6. To save all settings and auto-exit the setting mode, wait for a few seconds.
7. To activate the daily alarm, press the ALARM
indicator appears on the LCD display.
Listening to an External Audio Source

Clock Setting

button to select 12 or 24 hour display format.

Alarm Operation

button to select alarm source BUZ (buzzer), RAD (radio) or iPhone
button from the remote control to
button from the remote
button and the corresponding alarm source
11
blink.