Sleep Timer Function - LENCO IPD-5300 Handbuch

Note:
- If "Wake to iPod" is selected but your iPod has not been docked, the alarm source will be redirected
to the Alarm Buzzer automatically when the alarm is reached.
- When "Wake to Radio" is selected, make sure the radio station which you want to wake to is tuned.
- To activate the daily alarm, the alarm
Note:
Following control operations are implemented from the remote control.
Wake to Buzzer
- When the alarm time is reached, the buzzer alarm will sound for 3 Minutes.
- It goes into Auto-snooze mode if no further button has been pressed.
The display shows the "SNOOZE" indicator. The buzzer turns off for the snooze time (around 10
minutes) then comes on again. This operation will be repeated three times. After the fourth alarm
is finished, the alarm will shut off until the same alarm time on the next day.
- You may also activate the snooze function manually after the alarm sounds by pressing the
SNOOZE button. The buzzer stops for the snooze time then comes again.
- To cancel the snooze before it expires, press the ALARM
- The snooze operation (including auto-snooze and manual snooze) can be repeated by 3 times
only.
- To stop the alarm immediately after the buzzer sounds, you can also press the ALARM
button. It resets itself for the following day.
Wake to iPod/iPhone or Radio
- When the alarm time is reached, the selected alarm source (iPod or Radio) will automatically turn
on. It starts softly and gradually becomes louder.
- It plays for 30 minutes then shuts off and resets itself for the following day.
- During the activation of the alarm source, you may press the SNOOZE button to activate the
snooze function. The alarm stops for the snooze time (around 10 minutes) then turns on again.
- To cancel the snooze before it expires, press the ALARM
- This manual snooze operation can be repeated three times. Each time the alarm turns on, it plays
for 30 minutes (without pressing the snooze button).
- To stop the alarm immediately after the alarm sounds, you may also press the ALARM
It resets itself for the following day.
Sleep to timer
This feature allows you to fall asleep to the radio or iPod for up to 120 Minutes.
The unit shuts off automatically when the time expires.
1. Press the button from the main unit or the STANDBY
turn the unit on.
2. Either tune to the desired radio station in radio mode or playback music from the iPod.
3. To select the sleep timer to turn the unit off after 15, 30, 45, 60, 90 or 120 minutes, press the
SLEEP button from the remote control repeatedly.The display shows the indicator. The unit
for the selected length
plays
4. You may press the SLEEP button once from the remote control to view the remaining sleep time,
if necessary.
5. To turn the unit off before the sleep timer counts down to zero, press the
main unit or the STANDBY
Note:
I f you are falling asleep to music from an external device connected to the AUX input,
the sleep timer will shut off the power to this system but it will not turn off the external device.
indicator should appear on the display.

Sleep Timer Function

of time then automatically turns off.
button from the remote control
12
button.
button.
button from the remote control to
button from the
at an y time.
button.