Display In Automatic Mode; Maintenance - Pentair NOCCHI VSDP Übersetzung Der Originalanleitung

DISPLAY IN AUTOMATIC MODE

When the device is in automatic mode, pressing
P L I N E P S E T
0 , 0 b a r 3
Standard
H z P S E T
5 0 3 , 0 b a r
Service
I P U M P
4 , 1 A
Current and temperature
FUNCTIONS AND ALARMS REGISTERS
In manual mode with the pump stopped simultaneously press the keys
keys, use the button ENTER to proceed to enter the log Once the last log has appeared, the display will show the main menu by
pressing ENTER. Display sequence:
+ 5 s
P L I N E P S E T
0 , 0 b a r 3 , 0 b a r
HOURS COUNTER. Number of operation hours
CYCLE COUNTER Number of operating cycles, one cycle is a start and a stop.
CONNECTION COUNTER. Number of connections to the power supply.
MAX PRESSURE The maximum pressure reached in the installation. It detects water hammer.
CONTACTOR SHORT CIRCUITS ALARM. Number of short circuit alarms
CONTACTOR OVERCURRENT ALARM. Number of alarms due to overcurrent.
CONTACTOR OVER TEMP. ALARM Number of alarms due to overheating.
CONTACTOR DRY ALARM. Number of alarms due to insufficient water.
The logs remain in memory even during disconnection from the mains
CHAPTER 6

MAINTENANCE

Before performing any work on the device, disconnect the power supply Make sure the power supply cannot be
accidentally restored. Intervene after the elapse of 2 minutes from disconnection to prevent possible electric shock.
Refer to the "safety instructions".
will result in different display modes:
, 0 b a r
P L I N E F L
2 , 3
T E M P .
2 0 º C
R U N N I N G T I M E
H O U R S 1 2 6 C Y C L E
A L A R M C O U N T .
D R Y R U N 2 0 O V E R T E M P .
1
MENU +
R E G I S T E R R E G I S T E R
8 4 2 5 P O W E R O N
A L A R M C O U N T . A L A R M C O U N T .
0 0 O V E R C U R R .
for 3s to obtain the functions and alarms
M A X P R E S S U R E
1 8 2 5 0 , 0 b a r
A L A R M C O U N T .
0 0 S H O R T C I R C .
EN
0 0
19