Function Selection; Error Messages - HQ Power VDP250MH14 Bedienungsanleitung

f. Function selection
Different functions can be set by means of the 3 push buttons and the display. When you switch the device on, the
display setting will be the same as before you turned it off.
Procedure: • Press the ENTER button for 3 seconds, the display will start flashing
• Press the UP button to select a different function
• Press ENTER to confirm the selected function or EXIT/DN to cancel
• The active function will flash. Switch it on or off using UP or EXIT/DN button
• Press ENTER again to confirm your settings
• Press EXIT/DN to save the setting and exit the menu
Please refer to the list below for the different settings:
S/N Function Option
display select
0 A A A A - - - - - - - - - - - - A001...A511
1 Run Run ON / OFF
Run Run
2 Focu Focu ON / OFF
Focu Focu
3 Disp Disp Disp Disp DP - x
4 RDIS RDIS RDIS RDIS ON / OFF
5 Rpan Rpan Rpan Rpan ON / OFF
6 Rtilt Rtilt Rtilt Rtilt ON / OFF
Rest Rest ON / OFF
7 Rest Rest
8 Inda Inda ON / OFF
Inda Inda
9 Lamp Lamp ON / OFF
Lamp Lamp
10 Ver Ver Ver Ver V – 1.0
11 Time Time Time Time OPEN
CLR
12 Test Test Test Test tE – 1
tE – 16
13 Cont Cont Cont Cont CN – X
14 Edit Edit Edit Edit SCE1
SCE15

6. Error Messages

When the device is switched on, it will make a reset first. The display may show "XERR" if there are problems with one
or more channels. "X" stands for any channel equipped with a position test sensor. For example, "2Err" means there
is an error in channel 2. Simultaneous errors on channels 1, 2 and 5 are shown as "1Err", "2Err","5Err" flashing
repeatedly for 5 times and then the device will reset all the stepper motors and generate a signal. If the errors remain
after 3 attempts, the device stop functioning if there are 3 or more errors. If there are less than 3 errors, the device
can still be operated with the exception of the erratic channels.
1 1 1 1 Err Err Err : Colour wheel error Err
VDP250MH14
Return to main
menu
√
√
√
√
√
√
√
√
√
√
√
√
√
√
↓
√
Par-1
↓
Par-n
TIME
CNIN
Parl
↓
Par-N
TIME
CNIN
Display
Axxx DMX start address setting
RUN Run pre-installed programme in the EEPROM
Focus, opens the shutter, selects white light
Dxxx Display the DMX value for each channel
Reverse display
Reverse pan
Reverse tilt
Reset
Install software into the EEPROM
Lamp ON/OFF control
Software version
Xxxx Lamp work time (future releases only)
Reset lamp work time
Test the function of each channel
1 1 xx Edit a scene without controller
↓
1 N xx
1 T – X The run time of that scene
ON/OFF Edit a scene through a controller
↓
F 1 xx Edit a scene without controller
↓
F N xx
F T – X The run time of that scene
ON/OFF Edit a scene through a controller
6
Function explanation
VELLEMAN