Ricoma PSP-990 Bedienungsanleitung Seite 9

STEP6-PRESSING
a. Lift the Pressing Handle(A). The Pressing Plate(B) moves to the up
position.
b. Carefully arrange the garment to be pressed onto the Ironing Board(C),(the
lower base of the Steam Press).
c. Grasp the handle of the Pressing Plate (A) and lower it onto the Ironing
Board( C ),capturing the garment between the two halves of the Steam Press.
For light duty pressing, simply lowering the handle and allowing the Pressing
Plate to rest on the Ironing Board will be sufficient. Return to the open position.
For heavier duty pressing, continue to grasp the handle and press downward until
the Pressing Plate is pushed to its lowest position, then open the press.
If the Temperature Control is set high enough you may give the fabric a burst
of steam by pressing a Steam Burst Button (D)to remove stubborn wrinkles.
While the Pressing Plate is in the open or up position, simply press down on a
Steam Burst Button(D)and release it , The fabric will be given a burst of steam.
d. After a few seconds, lift the handle and raise the Pressing Plate back to the
raised position.
IMPORTANT NOTE: If you forget to raise the Pressing Plate or become
distracted, the machine will give a warning beep and automatically shut-off
after approximately 10 seconds, The steam press will also shut-off after 15
minutes of no activity with the press in the open position.
Auto Shut-Off does NOT disconnect the power. Power is always on and the
power light remains on as well until the power switch is turned OFF. The shut-
off feature is a temporary aid until you can give full attention to the unit again.
Page 8
Steam Press Instruction Manual