Ricoma PSP-990 Bedienungsanleitung Seite 4

IDENTIFYING THE STEAM PRESS PARTS
1.The Pressing Handle raises and lowers the Pressing
Plate. By lowering the Pressing Handle until it reaches
the lowest point possible you automatically obtain
maximum pressure.
2.The Locking Knob will lock together the pressing
Plate and Ironing Board. Use the Locking Knob to
carry or Store the Steam Press.
3.The Steam Burst Buttons on either end of the handle
grip produce a burst of steam when pressed.
4.The Pressing Plate is the temperature controlled
surface that heats and presses the fabric.
5.The Ironing Board is the padded surface that holds the
fabric during pressing.
6.The Power Indicator Light is illuminated when the
unit is on.
7.The ON/Off Switch can be pushed to turn the power
on and off.
8.The Ready Light goes off when the Press has reached
the selected temperature.
9.The Steam Ready Light goes on when unit is ready to
produce bursts of steam.
Steam Press Instruction Manual
10.The Temperature Control dial is used to set the desired
temperature for each fabric.
11.The Water Tank slides forward and is filled through holes
in the top. The Water level can be seen through the front
of the tank. Slide the tank forward for a better view.
6 8
1
3
9 2
11
7
10
4
5
Page 3