Troubleshooting - Ricoma PSP-990 Bedienungsanleitung

TROUBLE SHOOTING THE STEAM PRESS
Below is a chart detailing the most common problems, their causes and solutions. Before shipping any appliance to a service
center please check to make sure that the solution is not listed here:
PROBLEM
Steam Press Cannot Be Opened
Using Pressing Handle.
Steam Press Becomes Warm
but DOES NOT Remove Wrinkles
Press DOES NOT get warm
Steam Press Instruction Manual
CAUSE
Locking Knob is in Locked Position
Temperature Setting is not high enough
for the fabric attempted.
Temperature has not been selected.
Press is not plugged into an outlet.
Automatic Shut-Off has engaged. The
Pressing Plate has been lowered for more
the 15 seconds without being raised.
Automatic Shut-Off has engaged. The
Pressing Plate has been raised for more
than 15 minutes without use.
SOLUTION
Turn the Locking Knob to the Unlocked
Position
Gradually increase the temperature until
obtaining the desired results.
Turn the Temperature Control Dial to
an appropriate setting.
Plug the appliance in.
Push the ON/OFF switch to the OFF
position and back to ON. Raise the
Pressing Plate during the warm-up period.
Push the ON/OFF switch to the OFF
position and back to ON. Raise or lower
the Pressing Plate to restart the heater.
Page 15