Funkwerk elmeg CS290-U Bedienungsanleitung Seite 8

Make sure phone cables are installed in a safe manner to prevent tripping.
•
Avoid the following:
•
Direct sunlight
Sources of heat (for example radiators)
Electronic devices (for example stereo components, office equipment or microwave devi-
ces)
Ingress of moisture or liquids
Aggressive fluids or vapors
Dusty environment
Do not use the unit in excessively humid rooms or hazardous locations.
•
Only open those sections of the device specified in the assembly / operating instructions.
•
Do not touch plug connectors with pointed, metal, or moist objects.
•
If you do not permanently mount the device or any accessories, be sure to place it/them on
•
a non-slip surface.
When required, clean the unit with a slightly moistened cloth.
•
Only use approved accessories.
•
Only terminals with SELV and/or which comply with ETS 300047 may be connected to the
•
unit. This regulation is fulfilled when approved terminal devices are used as intended.
Plug-in power supply
Use only approved power plug-in units (DSA-0101F-05 UP or L15 D52 AB DDLAWO).
•
Do not use power plug-in units with visible defects or damage (fissures, cracks, etc.)
•
Elektrostatic charges (protection against electrostatic charges)
The telephone is supplied with enhanced ESD protection against the effects of electrostatic
discharge that exceeds the protection level cited in the approval specification. Elevated ESD le-
vels should nevertheless be avoided to the greatest possible extent. In some cases, electrostatic
discharge levels can far exceed the approval limits or the resistance levels already implemented
in your telephones. Eliminate the causes or conditions that promote these elevated ESD levels,
such as insufficient humidity or carpeting. The telephone manufacturer does not assume any
liability for damage caused under such circumstances.
Scope of supply
System telephone, Handset with connection cord, Connection cable, 2 feet, Operating instruc-
tions, Label panel for programmable function keys. Adapter cord (CS290-U) for headsets equip-
ped with 4-pin connecting cord (8-pin plug / 4-pin cord).
Care and maintenance
The ISDN system telephone has been manufactured for normal, everyday use. When required,
clean the ISDN system telephone with a slightly moistened cloth, or with an anti-static cloth. Ne-
ver use a solvent to clean the phone! Never use a dry cloth; electrostatic charges could damage the
electronics in the system. It is essential that no liquids penetrate into the inside of the ISDN sys-
tem telephone, as this could destroy the phone.
Installing the telephone
Before installing the telephone you must mount the rear feet for the telephone at the positions
shown in figure . Depending on the height of these two feet you can adjust the display angle of
your phone to your personal angle of vision. Ensure that the two feet have the same height.
To adjust the height, pull the feet off of the bottom of the telephone, rotate them around 60° and
4
6