Corega BAR-WL Bedienungsanleitung Seite 28

3. Double-click "Protocol" on the Select Network Component Type or highlight "Protocol" then click "Add".
4. Highlight "Microsoft" under the list of manufacturers.
Double-click "TCP/IP" from the list on the right or highlight "TCP/IP" then click "OK" to install TCP/IP.
5. After a few seconds, you will be brought back to the Network window. The TCP/IP Protocol should now be on the list of
installed network components (see 2 above).
6. Click the "Properties" button.
The TCP/IP Properties window consists of several tabs. Choose the "IP Address" tab.
26