Onepage Setup With Pppoe On The Wan - Corega BAR-WL Bedienungsanleitung

2.3.3 OnePage Setup with PPPoE on the WAN

PPPoE is a dial-up type connection type provided by some ISPs. Note that if you select PPPoE, please remove any existing PPPoE
applications on any PCs on your LAN.
• User Name
Enter the user name your ISP provide to you.
• Password
Enter the password your ISP provide to you.
• Connect-on-demand
Is a utility to trigger the PPPoE session when it is on disconnection status and there is packet being going out through WAN
port. Check the "Connect on Demand" box to make this function active, and you can enter the number of how many
minutes you wish to disconnect after network is idled in the "Max Idled Time" location. This is only used with the ISP bills
per megabyte or per second of useage.
• Keep Alive
This function keeps your PPPoE connection alive even if there is no data to transmit. However, in some situations, PPPoE
sessions cannot be re-connected immediately after a disconnection because the system on ISP site may need a little time to
restore. You may need to check your ISP to get the information that how much time it need to wait before the router start to
re-build the PPPoE session and fill it in the "Redial Period".
• Domain Name Server (DNS)
Your ISP will provide you with at least one DNS IP Address. Multiple DNS IP settings are common. The first available DNS
entry is used in most cases.
• Private IP Address
This is the LAN IP address of the Router. This is the address that is used to configure the router. The default values are:
192.168.1.1 for IP Address and
255.255.255.0 for Subnet Mask.
For setting up of the wireless, see section 2.3.1
12