Replacing The Lamp - Sony VPL-FX30 Kurzreferenz

Replacing the Lamp

eplace the lamp with a new one if a message displayed on the projected image or the LAMP/
COVER indicator notifies you to replace the lamp.
Use an LMP-F230 projector lamp (not supplied) for replacement.
Caution
• The lamp remains hot after the projector is
turned off. If you touch the lamp, you may
burn your finger. When you replace the
lamp, wait for at least an hour after
turning off the projector for the lamp to
cool sufficiently.
• Do not allow any metallic or inflammable
objects into the lamp replacement slot after
removing the lamp, otherwise it may cause
electrical shock or fire. Do not put your
hands into the slot.
• If the lamp breaks, contact qualified
Sony personnel. Do not replace the lamp
yourself.
• When removing the lamp, be sure to pull it
out straight, by holding it by grab. If you
touch a part of the lamp other than the grab,
you may be burned or injured. If you pull out
the lamp while the projector is tilted, the
pieces may scatter if the lamp breaks any
may cause injury.
1
Turn off the projector, and disconnect
the AC power cord from a wall outlet.
2
When the lamp has cooled
sufficiently, open the rear panel by
loosening the three screws.
3
Loosen the three screws on the lamp
then pull out the lamp by its grab.
Replacing the Lamp
Rear
Screws
Burn-out
Grab
Screws
15
GB