Hdx Noise Reduction; Connector Assignment - Sennheiser Evolution Wireless series Bedienungsanleitung

XLR-3 connector (EM 500)
balanced unbalanced
3.5 mm stereo jack plug (lockable)
(SK 500)
HDX noise reduction
Dynamic range of the AF signal RF signal (max. 60 dB)
Transmitter
Progress you can hear:
The evolution wireless Series is equipped with HDX, the new Sennheiser
noise reduction system that reduces RF interference. It increases the signal-
to-noise radio in wireless audio transmission to up to 110 dB.
HDX is a wideband compander system which compresses the audio signal in
the transmitter in a 2:1 ratio (related to dB) to lift it above the inherent noise
floor of the RF link. A 110 dB dynamic range signal is thus transmitted with
an effective dynamic range of only 55 dB, which is above the 60 dB noise
floor of the RF link. In the receiver the signal is expanded in an identical and
opposite way in a 1:2 ratio to restore the original signal, at the same time
reducing the RF noise to below the noise floor of the receiver. Giving a radio
link with a better signal-to-noise ratio than a CD.
HDX has been specially developed for high quality radiomicrophone systems.
Note:
Only transmitters and receivers that are equipped with
with each other. If non HDX
range would be drastically reduced and the transmission would sound blunt
and flat. HDX is permanently active and cannot be switched off.

Connector assignment

1 / " (6.3 mm) stereo jack plug (EM 500)
4
balanced
3.5 mm stereo jack plug (lockable)
balanced
DC connector/Power supply
Inherent noise
of the RF link
HDX
equipment was mixed with HDX, the dynamic
unbalanced Headphones
unbalanced Headphones
Receiver
can work correctly
87