Removing The Child Safety Seat - Foppapedretti CS28 Montageanweisungen

GB
INSTRUCTION MANUAL
Keep the instruction manual in the compartment at the centre of the base (14) so that it can be
consulted whenever necessary.
Consult the infant car seat group 0+ (type CS28) and base 0+ instruction manual for information on
how to install and secure the base 0+ correctly, how to fasten the infant car seat to the base, how to
position and fasten baby in the infant car seat and how to regulate the handle of the infant car seat
correctly.
Read the warnings on the products carefully and the instruction manual and keep for future reference.
IMPORTANT
The base 0+ is standard approved according to the regulation ECE R44/04, the European regulation
concerning the safety of infant car seats and it must only be used together with the infant car seat
Group 0+ (type CS28).
The model of the infant car seat is stated on the label fitted on the product.
CS28B

REMOVING THE CHILD SAFETY SEAT

Pull up the red release handle in front of the base, unlock the carrier
from base, at the same time lift up the carrier vertically, then the
carrier can be taken out.
ATTENTION:
When taking the carrier out of the base, please check and confirm the
handle is on vertical position to avoid baby falls out from the carrier.
Please do not unbuckle vehicle belt, until the carrier.
10