Troubleshooting - Lincoln Quicklub 236-10697-1 Benutzerinformation

User Manual
Operating Instructions
NOTE
The pump operation can be stated from the outside by:
- the rotating stirring paddle (e.g. by t riggering an additional lubrication cycle)
- the LEDs of the control p.c.b. (see chapter "Fault indicat ion")
- the signal lamp of the illuminated pushbutton (option)
6 001a0 2
Fault: The pump motor does not run
Cause:
Power supply to the pump interrupted
Power supply to the control p.c.b.
i nterrupted
Control p.c.b. defective
Electric motor defective
Fault: Right-hand LED 3 (see fig. 9) flashes
Cause:
One of the two rotary switches 2, 4 is
on „0".
Signal: 4 flashes
Short circuit a t pushbutton of the
control p.c.b. or, if present, at the
external illumi nated pushbutton or a t
their connecting parts.
Signal: 3 flashes
Page 8 of 20
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259

Troubleshooting

Remedy ...
Check the power supply and fuses.
If necessary rectify the fault and/or replace the fuses.
Check the line leading from the fuses to the pump plug.
Check the line leading from the pump plug and t he control
p.c.b.
If the power supply is connected, the left-side LED is lit (see
4273 a00
fig. "PCB 8").
Check the function of t he p.c.b. (see fig. "PCB 8"). If necessary replace the p.c.b.
Check the power supply to the motor. I f necessary, replace the motor.
Remedy: ...
Set rotary switch to a number or a letter.
Check whether the short circuit is at t he PCB or, i f present, at the il luminated
pushbutton. If necessa ry, exchange the PCB or the ill uminated pushbutton.
2.6EN-28006-B10
by service personnel
by service personnel