Philips 9898 031 37651 Gebrauchsanweisung Seite 8

Cautions:
• Never sterilize the Adapter Cable by any means.
• You can immerse the patient end of the Adapter Cable, but no longer than specified by the cleaning
agent or disinfectant manufacturer. Do not immerse the Fetal Monitor connector.
• Select recommended cleaning agents and disinfectants carefully, because some products with similar
names have different compositions.
• Always dilute cleaning agents and disinfectants according to manufacturers' instructions.
• Do not use strong oxidants or bleaches containing sodium hypochlorite (e.g. Clorox™).
• Do not use Povodine
• Do not use disinfectants containing iodine complexes.
Exterior Cleaning and Disinfection
Perform the following procedure after every use:
Step Cleaning and Disinfecting After Every Use
Press the cover over the Flush-Cleaning Port
1
assure it is closed.
2 Spray cleaning agent directly onto the Adapter Cable, or
onto a soft, clean cloth. You can also immerse the patient
end of the Adapter Cable.
3 Wipe all Adapter Cable surfaces clean from one end to
the other.
4 Change to a dry cloth and dry the Adapter Cable com-
pletely.
5 Repeat steps 1-4 using a recommended disinfectant.
6 Using a clean, dry cloth, wipe all residual disinfectant
from the Adapter Cable.
WARNING: Any residual disinfectant left on the cable
could cause severe skin irritation or blistering if it
comes in contact with a patient.
7 If you immersed the patient end of the Adapter Cable,
rinse the internal cavity following
procedure, Cleaning the Internal Cavity.
8 Check for signs of any deterioration or damage. If dam-
age is noticed, discard the Adapter Cable immediately.
® ®
, Sagrotan , Mucocit
steps 4 and 5 in the next
®
-P or strong organic solvents.
to
Flush-
Cleaning
Port
4
Patient End of
Adapter Cable
Spiral Electrode
Input
Snap-Connector
(not visible)
Cable-Connector
to Fetal Monitor