Start/Stop; Setting Temperature; Setting Humidity Level; Setting Start Time And Calendar Programming - Tylo SENSE COMBI Gebrauchsanweisung

6

Start/stop

To start the heater:
1. Pass your hand over the screen to light it up. ON/OFF is
marked (light intensity increases) (see Figure 7, Page 6).
Figure 7: ON/OFF and ON/OFF STATUS
2. If ON/OFF is not marked, use UP to scroll to the correct posi-
tion.
3. Press OK. ON/OFF STATUS will light up in the STATUS BAR
(see Figure 4Figure 6, Page 3) to show that the sauna heater
is on.
When the heater is on, the temperature and time will be shown if
no other settings are changed.
To switch off, select ON/OFF and press OK.
NOTE! When the heater is switched off or the set op-
erating time expires, it will switch into drying mode. The
heating element will run for 20 minutes to dry out the
sauna cabin. This can be deactivated by pressing ON/
OFF. When the heater is off, the control panel light will
go out. It is automatically activated when you pass your
hand over the panel. Tylö recommends using the drying
mode.

Setting temperature

To set sauna temperature:
1. Select TEMPERATURE (see Figure 8, Page 6) and
press OK.
Figure 8: TEMPERATURE
2. Use UP and DOWN to set the temperature and confirm with
OK.
At temperature settings over 70°C, sauna cabin heating will
be prioritised, and at temperature settings under 70 °C, steam
production will be prioritised. Prioritisation can be changed in
Settings (see The section called The SETTINGS menu, Page
7).

Setting humidity level

To set humidity level:
1. Select HUMIDITY (see ) and press OK.
Figure 9: HUMIDITY/HUMIDITY STATUS for empty, half-full
and full reservoir.
2. Set the desired humidity level on the scale of 0-10 (0 = dry
sauna and 10 = max. humidity). Confirm with OK.
Water level in the reservoir is indicated by HUMIDITY STATUS
(see ) in the STATUS BAR (see Figure 4Figure 6, Page 3, pos
6). An illuminated, full drop symbol shows the reservoir is full. An
illuminated half-full symbol shows the reservoir is half full and a
flashing empty symbol shows the reservoir is empty. When start-
ing, an empty reservoir will also be indicated by a pulsating audio
signal.
If the water runs out during your sauna, it will be indicated by a
pulsating audio signal and flashing symbol on the panel. When
filling with water, HUMIDITY STATUS will first change to half-full
and then to full, and a steady audio signal will indicate that the
reservoir is full.
Fill the water reservoir via the opening on the right of the air hu-
midifier and fragrance holder.
Figure 10: Filling the water reservoir.

Setting start time and calendar programming.

You can set a time when the heater is to start up to 24 hours in
advance. You can also set up a weekly program (activities) of
start and stop times, temperature, which days the program ap-
plies to (up to one week in advance) and select whether the activ-
ity should be repeated or not.
To set up a start time:
1. Select TIMER (see Figure 11, Page 6).
Figure 11: TIMER and TIMER STATUS
2. Press OK.
3. Select Timer .
4. Select Start time.
5. Enter the start time and set the correct time. Use UP/DOWN
to increase or decrease the value. Confirm each digit with OK.
When a time is programmed, TIMER STATUS (see Figure 11,
Page 6) is shown in the STATUS BAR in the main menu.
To activate a preprogrammed time:
1. Select TIMER.
2. Select Activate.
3. Confirm with OK.